ja, hele prettige synths zijn dat spul van DSI.
Heb je de kap open moeten maken om er bij te komen, dus alle 88 potcaps eraf trekken en dan open schroeven? Of is gewoon een beetje erin druppelen ook okay?
Alvast bedankt voor je antwoord
Ja je moet hem wel even helemaal uit elkaar halen.
Daar keek ik ook wel een beetje tegenop, ik ben echt helemaal niet technisch, maar het valt uiteindelijk allemaal best mee.
Dit zijn de instructies die ik gevolgd heb:
"The best way to apply the Deoxit is to remove the panel boards. This is the way I typically do it here:
It's a lot easier to remove the knobs before you open it up. They fit pretty tightly, but they should just slide off and on.
Then remove the 4 screws from the front panel and the 8 screws across the back. Place something soft (blanket, towel, bubble wrap, etc.)
behind your Prophet. Lift off the top and lay it face down on the soft material.
Disconnect any of the ribbon cables that prevent you from removing the specfic panel board.
Then remove the board screws and lift out the board.
When you look at the encoders, you will see that there are 3 leads connecting each one to the board. On the side opposite the leads,
there is a very small gap between the metal top of the encoder and the plastic housing.
That gap is where you should apply the Deoxit.
Lean the board up against something so that it is almost vertical, with the lead side of the encoders facing down.
Apply a drop of the Deoxit to the gap on the encoder. The 100% solution is kind of thick, so it may take a few seconds for it to work its way in.
Subsequent drops typically sink in faster. As you apply the Deoxit, turn the encoder shaft to spread the cleaner inside the encoder.
It will probably take about 3 drops. That usually does it."
Dit lijkt heel veel, en het lijkt misschien zelfs onmogenlijk als je het gleufje
ziet waar de deoxit druppeltjes in moeten, maar het kan echt !
Het is mij ook gelukt. Het spul wordt ook echt de encoder ingezogen als je hem heen en weer draait.
Misschien moet je anders eerst één of twee druppeltjes per encoder proberen. Zal ook best werken.
Maar ik heb gewoon meteen in alle encoders drie druppels gedaan.
Steeds een druppel, dan even 10 keer heen en weer draaien, en dan de volgende druppel.
Alle encoders drie druppels moet nèt kunnen met één zo'n klein tubetje.
Succes !