GENELEC 1037B
SYSTEM SPECIFICATIONS
SYSTEM
Lower cut-off frequency, -3 dB: £ 35 Hz
Upper cut-off frequency, -3 dB: ³ 22 kHz
Free field frequency response of system: 37 Hz - 21 kHz (+/-2.5 dB)
Maximum short term sine wave acoustic output on axis in half
space, averaged from 100 Hz to 3 kHz:
@ 1 m ³ 116 dB SPL
Maximum long term RMS acoustic output in same conditions
with IEC-weighted noise (limited by driver unit protection circuit):
@ 1m ³ 107 dB SPL
Maximum peak acoustic output per pair on top of console,
@ 1.7m from the engineer with music material: ³ 126 dB
Self generated noise level in free field @ 1m on axis: £ 15 dB (A-weighted)
Harmonic distortion at 95 dB SPL at 1m on axis: freq. <100 Hz <3%
freq. >100 Hz <0.5%
Drivers:
Bass
Mid
Treble 305mm (12") cone
130 mm (5") cone
25mm (1") metal dome
Weight: 37 Kg (82 lb)
Dimensions: Height 680mm (26 3/4")
Width 400mm (15 3/4")
Depth 380mm (15")
AMPLIFIER
Bass amplifier output power with a 8 Ohm load: Short term 180W
Midrange amplifier output power with a 8 Ohm load: Short term 120W
Treble amplifier output power with a 8 Ohm load: Short term 120W
Long term output power is limited by driver unit protection circuitry. Slew rate : 80V/micros
Amplifier system distortion at nominal output: THD £ 0.05%
SMPTE-IM £ 0.05%
CCIF-IM £ 0.05%
DIM 100 £ 0.05%
Signal to Noise ratio, referred to full output: Bass ³ 100 dB
Midrange ³ 100 dB
Treble ³ 100 dB
Mains voltage: 100/200V or 115/230V
Voltage operating range at 230V setting: 207 - 253V (+/-10%)
Power consumption: Idle 50W
Full output 300W
CROSSOVER
Input connector: XLR female pin1 gnd
pin2 +
pin3 -
Input impedance: 10 kOhm
Input level for 100 dB SPL output @1m: variable from +6 to -6 dBu
Input level for maximum short term output of 116 dB SPL @1m: variable from +22 to +10 dBu
Subsonic filter below 32 Hz : 18 dB/octave
Ultrasonic filter above 25 kHz: 12 dB/octave
Crossover frequency: Bass/Mid 420 Hz
Mid/Treble 3.2 kHz
Crossover acoustical slopes: 18 - 24 dB/octave
Crossover level control operating range in 1 dB steps: Bass from 0 to -6 dB
Mid from 0 to -6 dB
Treble from 0 to -6 dB
Bass roll-off control in 2 dB steps: from 0 to -8 dB @35 Hz
Bass tilt control in 2 dB steps: from 0 to -8 dB @80 Hz
The 'CAL' position is with all tone controls set to 'off'
and input sensitivity control to maximum.
prijs 3000 euro voor de set
SYSTEM SPECIFICATIONS
SYSTEM
Lower cut-off frequency, -3 dB: £ 35 Hz
Upper cut-off frequency, -3 dB: ³ 22 kHz
Free field frequency response of system: 37 Hz - 21 kHz (+/-2.5 dB)
Maximum short term sine wave acoustic output on axis in half
space, averaged from 100 Hz to 3 kHz:
@ 1 m ³ 116 dB SPL
Maximum long term RMS acoustic output in same conditions
with IEC-weighted noise (limited by driver unit protection circuit):
@ 1m ³ 107 dB SPL
Maximum peak acoustic output per pair on top of console,
@ 1.7m from the engineer with music material: ³ 126 dB
Self generated noise level in free field @ 1m on axis: £ 15 dB (A-weighted)
Harmonic distortion at 95 dB SPL at 1m on axis: freq. <100 Hz <3%
freq. >100 Hz <0.5%
Drivers:
Bass
Mid
Treble 305mm (12") cone
130 mm (5") cone
25mm (1") metal dome
Weight: 37 Kg (82 lb)
Dimensions: Height 680mm (26 3/4")
Width 400mm (15 3/4")
Depth 380mm (15")
AMPLIFIER
Bass amplifier output power with a 8 Ohm load: Short term 180W
Midrange amplifier output power with a 8 Ohm load: Short term 120W
Treble amplifier output power with a 8 Ohm load: Short term 120W
Long term output power is limited by driver unit protection circuitry. Slew rate : 80V/micros
Amplifier system distortion at nominal output: THD £ 0.05%
SMPTE-IM £ 0.05%
CCIF-IM £ 0.05%
DIM 100 £ 0.05%
Signal to Noise ratio, referred to full output: Bass ³ 100 dB
Midrange ³ 100 dB
Treble ³ 100 dB
Mains voltage: 100/200V or 115/230V
Voltage operating range at 230V setting: 207 - 253V (+/-10%)
Power consumption: Idle 50W
Full output 300W
CROSSOVER
Input connector: XLR female pin1 gnd
pin2 +
pin3 -
Input impedance: 10 kOhm
Input level for 100 dB SPL output @1m: variable from +6 to -6 dBu
Input level for maximum short term output of 116 dB SPL @1m: variable from +22 to +10 dBu
Subsonic filter below 32 Hz : 18 dB/octave
Ultrasonic filter above 25 kHz: 12 dB/octave
Crossover frequency: Bass/Mid 420 Hz
Mid/Treble 3.2 kHz
Crossover acoustical slopes: 18 - 24 dB/octave
Crossover level control operating range in 1 dB steps: Bass from 0 to -6 dB
Mid from 0 to -6 dB
Treble from 0 to -6 dB
Bass roll-off control in 2 dB steps: from 0 to -8 dB @35 Hz
Bass tilt control in 2 dB steps: from 0 to -8 dB @80 Hz
The 'CAL' position is with all tone controls set to 'off'
and input sensitivity control to maximum.
prijs 3000 euro voor de set
