DigiLoog
Ouwe rot
Aangboden een MIDI to CV converter van Philip Rees met instelbaar midikanaal (1-16), prijs 100 euro.
Specificatie :
The CV output also has a wide range available: from -10V to +20V. A tuning preset adjustment is provided to set the V/oct offset or V/Hz slope. A trim preset lets you finely match your target instrument with respect to the slope for V/oct, or the offset for V/Hz.
The default trigger mode is multiple for legato playing, but you can change this via the Legato Footswitch MIDI message.
The three MIDI Sostenuto, Sustain and Hold 2 commands are all fully implemented.
A simple slide switch lets you choose between 5V positive, 10V positive and S-trig (negative current gate, Moog style) for the gate output.
The pitchbend firmware can use the full 14-bits of the MIDI pitchbend value. This combines with the 16-bit conversion to give clean stepless glissando if you have a suitable high resolution source of pitch wheel data. The default pitchbend range is plus-or-minus one octave. The standard MIDI 'pitchbend sensitivity' Registered Parameter is observed, so you can alter the bend range if required.
Under MIDI control, the Little MCV digitally generates a precise triangular low frequency oscillator (LFO) signal, which may be added to the CV output - to create a high quality pitch vibrato. The LFO depth is controlled by the product of the MIDI Modulation Wheel and a value derived from the Tremolo Depth Controller (see graph below). The LFO speed is conveniently set by MIDI Non-Registered Parameter Number 00.
The portamento (pitch-to-pitch glide) response is exponential and free of irregularities. The MIDI 'Portamento On/Off and Portamento Time messages are observed.
The ACTIVE lamp indicates when the gate signal is asserted.
Geen adapter nodig werkt gewoon op 220V.
Specificatie :
The CV output also has a wide range available: from -10V to +20V. A tuning preset adjustment is provided to set the V/oct offset or V/Hz slope. A trim preset lets you finely match your target instrument with respect to the slope for V/oct, or the offset for V/Hz.
The default trigger mode is multiple for legato playing, but you can change this via the Legato Footswitch MIDI message.
The three MIDI Sostenuto, Sustain and Hold 2 commands are all fully implemented.
A simple slide switch lets you choose between 5V positive, 10V positive and S-trig (negative current gate, Moog style) for the gate output.
The pitchbend firmware can use the full 14-bits of the MIDI pitchbend value. This combines with the 16-bit conversion to give clean stepless glissando if you have a suitable high resolution source of pitch wheel data. The default pitchbend range is plus-or-minus one octave. The standard MIDI 'pitchbend sensitivity' Registered Parameter is observed, so you can alter the bend range if required.
Under MIDI control, the Little MCV digitally generates a precise triangular low frequency oscillator (LFO) signal, which may be added to the CV output - to create a high quality pitch vibrato. The LFO depth is controlled by the product of the MIDI Modulation Wheel and a value derived from the Tremolo Depth Controller (see graph below). The LFO speed is conveniently set by MIDI Non-Registered Parameter Number 00.
The portamento (pitch-to-pitch glide) response is exponential and free of irregularities. The MIDI 'Portamento On/Off and Portamento Time messages are observed.
The ACTIVE lamp indicates when the gate signal is asserted.
Geen adapter nodig werkt gewoon op 220V.
want hij is 
