Heb een P4C800deluxe met firewire. (met VIA OHCI Compliant IEEE 1394 Host Controller)
Het probleem volgens de helpdesk van tascam is de Via?? weet iemand dit nader te verklaren??
Het probleem doet zich bij mij ook voor. En schijnt dat we een andere firewire kaart moeten hebben dan een onboard firewire. Het probleem is bij mij wel (gek genoeg) minder als ik hem op het frontpanel aansluit ipv de firewire achterop de kast. Gelukkig heb ik er een voorop zitten, gezien de kasten die er zijn die er voorop geen hebben. Ik was er wel vanuit gegaan dat het zo allemaal wel goed moest zijn. Maargoed, het zal wel goedkomen.
i.i.g. denk ik dat het volgende beter zal werken:
ga naar
www.tascam.com en haal daar eerst je flash file om je tascam te flashen.
Installeer dan pas driver 1.40
Haal je firewall (komt met sp2) van je firewire-netwerkverbinding af en dus schakel hem uit. (in netwerkverbindingen of in apparaat beheer)
Zet eerst je pc aan en dan pas je tafel, daarna Soft lcd en dan pas cubase.
Als er iemand meer tips of wat dan ook heeft?
Oja nog iets. Ik had tascam gemaild en ze vertelden me, na een hoop vragen gesteld te hebben aan hun, dat er snel een cubase sx3??? (weet ik niet meer zeker ondersteuning bij kwam. De datum is al wel ruim overschreden dus ga ik nu toch geloven dat die nieuwe ondersteuning zoals ze het noemden, al in 1.40 zit!!!??? Laten we het niet hopen. Dit kan beter werken. Maargoed, het zal wel weer goedkomen.
Hieronder nog die mailtjes.
--------------------------------------------------------------------------------------------------------------------
05-01-2005 - Dear Alex,
we had a few rare cases where a Texas Instruments Chip worked better then a VIA, but most of the time it is more a System configuration problem, like a not switched off network connection for the firewire port, or a ressource conflict like shared Interrupts. Or by using low end Firewire Cables.
But it might be worth to try an alternative Firewire Card with a TI Chip, specially if it sometimes happens that the Firewire LED on the
FW-1884 goes off.
2. We can not define any special PC, as the availability of components is changing to fast, but on most of the current systems you should not get any problems with the FW-1884.
3. We are still working on the Plug In, but It is not finished yet.
Best regards
Dirk
---------------------------------------------------------------------------------------------------------------------------
26-11-2004 - Dear Alex,
After Steinberg changed the way of Remote Controlling for Cubase SX and Nuendo since SX 3, we have been enabled to start to create our own control Plug In for the FW-1884. Unfortunatly this will take a few more weeks, but our developers are heavily working on it.
Best regards
Dirk