Waldorf M, Wavetable Synthesizer

waldorf-teaser-synthesizer-microwave.jpg


Als je een rode knop op een marineblauwe oppervlakte ziet, denk je natuurlijk meteen aan de datacontroller van de Microwave of Microwave II. Maar lijkt het bij nader inzien niet meer op een knop? En waar is de ergonomische inkeping voor de vingertop? Even afwachten dus, wie we als oude vriend mogen verwelkomen.

bron: https://twitter.com/waldorfgmbh?lang=en

Update 14 september​

door: @theemagician

M_Banner.jpg


Waldorf keert volgens eigen zeggen terug naar zijn roots. Het bedrijf heeft de M uitgebracht, een Hybride Desktop Wavetable Synthesizer. De inspiratie komt van de classic Microwave en de modernere microwave II. De synth is voorzien van een analoog lowpass 24 dB/Oct VCF (SSI 2144 Improved Ladder Type) met resonance en analoge saturation feature, een stereo analogue VCA met panning opties en nogt veel meer. De synth komt met 2048 presets, verdeeld over 16 banksvan elk 128 sounds. Meegeleverd worden o.a. de klassieke MW1 Factory Sound Set, MW1 Soundpool 1-5, Analogue Bassco en de PPG Wave 2.3. Verder is de M voorzien van een ARP (arpeggiator) en MIDI-syncable global LFO.

De M is 8-stemmig polyfoon en gaat 1799 euro kosten.



bron:
 
Laatst gewijzigd:
Vladimir Salnikov van Waldorf schrijft het een en ander over het filterontwerp:

"initially, I consider doing this feedback chain to compensate for this ladder amplitude drop (to be closer to the wonderful CEM3389). One of the very early prototypes had it implemented, and Wolfram Franke after evaluation told me, that it sounds very close to the original Curtiss VCF. Actually, Curtiss 3389 has this compensating circuit implemented on the silicon, the rest is close to the SSM2044/SSI2144 in the filter area of this chip. But honestly, it was a finding of balance between all requirements - case, thermal stability, the complexity of routing, productions complexity, etc, etc, etc. It also requires extra ICs to implement this properly. So I had to decline this compensation circuit around and make VCF straightforward 2044 type. As extra, saturation was added (although it requires no extra ICs, only different values of certain passives). It has also its own charm, in my humble opinion, and perhaps, allow somebody to go close to Ppg Wave 2.3 sound too (as there was also no loudness drop compensation implemented.)"
Yep,de bass balls zijn weg,net als een MonoPoly,die heeft ook 4 osc. maar blijft mager klinken...(''close to the...'',nee man de sound echt niet hoor,dommerik)

Domme keuze natuurlijk
 
De Q heb ik nooit gehad. Maar ik heb hier een Microwave 1 en een Microwave 2, en hoewel ze tot op zekere hoogte patch compatibel zijn is de klank een wereld van verschil.

De microwave 1 klinkt door de 8-bit wavetables en door de primitievere DA-conversie en interpolatie veel rauwer. Maar heeft tegelijkertijd veel meer power.
Volgens mij is wat veel mensen de wat saaie Waldorf klank vinden begonnen met de Microwave 2, de Q, en tegenwoordig de Blofeld. Ik kan deze klank ook zeker wel waarderen maar ik hoop stiekum dat de M weer als vanouds klinkt.

Uiteindelijk gaan mijn Microwaves er denk ik wel en keertje uit, en ik heb nog wel wat ruimte op mn bureau voor een mooie desktop machine... 8)
he patch compatible?? dus de mw 1 patches gaan wel in 2?? hoe dan?
 
trouwens de mw1 kun je
Yep,de bass balls zijn weg,net als een MonoPoly,die heeft ook 4 osc. maar blijft mager klinken...(''close to the...'',nee man de sound echt niet hoor,dommerik)

Domme keuze natuurlijk
MonoPoly MAGER????????? huuuuu????? Welke heb jij gebruikt? Of te veel vince clarke reviews gelezen... de trick is dat je niet alle 4 de osc's gebruik 2/3 meer dan genoeg. dat ding is zo kkneetaaaaahhh dik man!! hoor dan
 
he patch compatible?? dus de mw 1 patches gaan wel in 2?? hoe dan?
Uit de MW 2 manual:

Converting MicroWave Sounds​

The MicroWave II/XT/XTk can also use Sound and Multi programs made for the first
MicroWave. It has a built-in converting feature to import these programs via MIDI dump.
Currently only the conversion of single sound programs is supported.
The MicroWave II/XT/XTk identifies such data by its model ID defined in the Sysex header.
Although conversion takes place automatically, there are some points you should keep in
mind:
• A converted program may not sound exactly the same as played in an original
MicroWave. Since the first MicroWave uses analog circuits, which may differ from
device to device, its impossible to make programs sound exactly the same.
• The MicroWave II/XT/XTk uses a Modulation Matrix with 16 slots. Theoretically, it
is possible that an "old" program uses more modulation assignments so that some
entries would get lost. Actually, there is only a little chance to get into trouble.
• The Filter Envelope of the MicroWave II/XT/XTk has no delay parameter. When an
imported program uses a delay setting other than 0 for this envelope, the
MicroWave II/XT/XTk will setup the Modifier Delay unit to handle this situation.
• The converted sound will reside in the current edit buffer, so it needs to be stored
manually
 
Uit de MW 2 manual:

Converting MicroWave Sounds​

The MicroWave II/XT/XTk can also use Sound and Multi programs made for the first
MicroWave. It has a built-in converting feature to import these programs via MIDI dump.
Currently only the conversion of single sound programs is supported.
The MicroWave II/XT/XTk identifies such data by its model ID defined in the Sysex header.
Although conversion takes place automatically, there are some points you should keep in
mind:
• A converted program may not sound exactly the same as played in an original
MicroWave. Since the first MicroWave uses analog circuits, which may differ from
device to device, its impossible to make programs sound exactly the same.
• The MicroWave II/XT/XTk uses a Modulation Matrix with 16 slots. Theoretically, it
is possible that an "old" program uses more modulation assignments so that some
entries would get lost. Actually, there is only a little chance to get into trouble.
• The Filter Envelope of the MicroWave II/XT/XTk has no delay parameter. When an
imported program uses a delay setting other than 0 for this envelope, the
MicroWave II/XT/XTk will setup the Modifier Delay unit to handle this situation.
• The converted sound will reside in the current edit buffer, so it needs to be stored
manually
dit is vet, nooit geweten! bedankt!
 
Grappig, ziet er best ouderwets uit zo. Geen solder mask, zo te zien maar 2 layers en redelijk grote onderdelen nog. Zo maakten ze 25 jaar geleden ook de Microwave I. Maar wel een gloednieuwe cirrus logic dac en een moderne ARM microcontroller.
Ben benieuwd waarom ze dit zo doen.

Heb 'ns gelezen op GS (dus neem het met een korrel zout) dat Waldorf in eigen land z'n spullen maakt. Kan dus zijn dat de productiefaciliteit op leeftijd is en erop ingericht is om het op de "ouderwetse" manier te doen. Zolang het je lukt om nieuwe ontwerpen zo te produceren, prima zal Waldorf waarschijnlijk denken.
 
Heb 'ns gelezen op GS (dus neem het met een korrel zout) dat Waldorf in eigen land z'n spullen maakt. Kan dus zijn dat de productiefaciliteit op leeftijd is en erop ingericht is om het op de "ouderwetse" manier te doen. Zolang het je lukt om nieuwe ontwerpen zo te produceren, prima zal Waldorf waarschijnlijk denken.
Klopt. Er staat ook made in germany achterop met kleine letters. Het zou me niets verbazen als ze de pcbs gewoon zelf maken. Juist als je het een beetje simpel houdt is dat best te doen. En de synths klinken er niet minder door.
Wel grappig want ik heb pas nog een rocket en een streichfett open gehad. Die zagen er wel weer wat moderner uit.
 
Klopt. Er staat ook made in germany achterop met kleine letters. Het zou me niets verbazen als ze de pcbs gewoon zelf maken.

Waldorf M productielocaties:
- the boards, cases, knobs are produced in Germany, Rhine region
- displays, and two internal cables assembly are delivered from China
- external PSU produced in Cambodia / Indonesia for a German company
- quickstart manual printed in Germany
- packaging and carton box produced in Germany
- final assembly, factory setup and tests - in Germany by Waldorf
 
Hij klinkt overduidelijk strakker (zal ik het zo noemen) met die SSM filters maar ik wil hem ook wel.
 
Back
Top