• Het Marktplaats Archief kan als naslagwerk worden gebruikt. Alle advertenties die in het archief staan, zijn gesloten en dus niet meer actief. De aangeboden producten zijn niet meer te koop. Advertenties worden naar dit archief verplaatst als de eigenaar de advertentie heeft gesloten of wanneer er langer dan 30 dagen geen activiteit op een advertentie is geweest.

    Het heeft dus geen zin om de aanbieders te benaderen met vragen over een product dat niet langer te koop wordt aangeboden. Doe dit dan ook niet. Het voorkomt ergernis.

Eurorack (MI, Make Noise Tiptop Audio, Harvestman and Wiard) en mungosync 2

Status
Er kan niet meer gereageerd worden.

Boost303

Mono-Amine
Lid sinds
11 juli 2001
Berichten
1.944
Locatie
DenHaag
Wat eurorack for sale ivm wijzingen in het rack:

Make Noise Mysteron 249 euro
Make Noise Moddemix 109 euro
Mutable Instruments Warps met Parasite firmware installed 179 euro
Wiard Borg filter, THE classic and musical filter 199 euro
Tiptop Audio 909 Clap, silver panel 99 euro
Harvestman / Industrial music Electronics Polivoks filter 149 euro

mungosync 2 magical clock/dinsync device 149 euro

Kaospad 3 249 euro

Liefst verkopen maar ik ben eventueel geïnteresseerd in een ruil met een Erica Drumsequencer, Erica Dual Drive, Erica drum dual modulator, Xaoc Zadar of Batumi met bijbetaling waar nodig

Fotos volgen op verzoek of in de komende dagen in dit topic

Modules kunnen worden opgehaald in DenHaag/Voorburg of verzenden, kosten en risico koper

Groet,

Joost
 
Tiptop 909 clap is verkocht

Komt bij:

MFB Dual LFO, resettable, eerste eigenaar, wordt niet meer gemaakt.

The DUAL LFO module houses two individual low frequency oscillators (LFOs) used mainly for modulation purposes. Each LFO section offers three selectable waveforms, CV-input with attenuator and a rate ranging from 10 seconds to approximately 100 Hz. By applying positive or negative voltage, this range can be widened with a factor up to 30, resulting in extreme slow or fast modulation rates.

Both LFOs offer individual inputs to reset the waveform, making it possible to synchronize to a sequencer with appropriate rate settings and separate reset-impulses.

LFO 1 offers triangle, saw tooth down and square waveforms, LFO 2 offers triangle, saw tooth up and sample & Hold. Output voltages are +/- 5 volts at maximum.

When not patched, the two CV-inputs are internally cross-wired, meaning that LFO 1 controls the speed of LFO 2 and vice versa with both attenuators being active to set modulation intensity.
 
Status
Er kan niet meer gereageerd worden.
Back
Top